Metal straight-edge (ruler).
Make fold lines by pressing against the edge of the ruler.
White craft glue that is a
“quick grab” “clear dry” type of glue.
X-acto blade tool and fresh
A true cutting mat
Small artist brush with which
to paint on glue
Small piece of aluminum foil to squeeze work glue onto.
This will act as your glue pot
Small detailing scissors,
a.k.a. as embroidery snips
Cut out all pieces for both games. Use the
straight edge ruler to press against fold lines.
This will give you clean straight creases. Fold at
all fold lines on all pieces.
Note: Use the blade
tool to cut the little tight spots such as those on
the donkey tails.
Take the planchette
storage box piece and place a layer of glue to the
long side tab.
2. Press tab against
inner side panel to form box.
Place glue to the bottom long tab and close up the
end of the planchette box.
Fold the planchette panels down the middle seam and
5. Trim the outer
rim of the planchette.
Use tweezers to position and glue the three black
beads to the under side of the planchette. These act
7. Take the
folded box top. Glue the tiny four tabs in place.
Glue down the lining panels found on each side of
the box top. Use tweezers to squeeze the glued fold
line. This makes the edges thin and uniform so that
the top will fit on the bottom. Repeat for both
boxes' tops and bottoms.
Fold the Ouija board in half and glue blank sides
Glue beads to underside of board or balsa wood
strips to make it look more realistic.